Saturday, 10 June 2017

Would this parallel LED lamp upset the working of the flywheel diode?


I'm using a solenoid with a fly-back diode 1N001 and a mechanical switch as in the below diagram:


enter image description here


Now I want to add this 24V indicator lamp in parallel with the solenoid as shown above to indicate the status of the valve.


My concern is would this lamp have an upsetting effect to the purpose/workings of the diode? If the lamp was pure resistive, I wouldn't ask this question but the lamp looks like made of LED.



Answer




No, you have nothing to worry about, assuming you have chosen the correct diode for your design. The current from the solenoid will flow through the diode as normal, especially if your lamp is an LED. The fly-back diode will clamp the reverse voltage to about 0.8V or so (its diode drop). Be sure your lamp can handle this reverse voltage. Then there should be no concerns.


If you lamp is just an LED in series with a resistor, the LED will be reverse biased and no current will flow in the lamp. If there's any active circuitry in it just be sure it can handle the ~ .8V of reverse voltage across it.


No comments:

Post a Comment

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...