UART frame has 1 start bit, 8 bit payload data, 1 or 2 stop bits. Frame structure and baud rate is agreed by both transmitter and receiver for successful data transmission. Start bit is used to synchronize and tell receiver that frame is started. Why there is a need of stop bit per frame, since all data frame to be transmitted will always be 8 bits (frame will always end with 8 bits)?
Subscribe to:
Post Comments (Atom)
-
Can you please give me a definition, or at least a more specific context, of the term "point-of-load" converter/regulator? I have ...
-
My input is an FM carrier of 80.00MHz. It is FM modulated with 625kbpsec data. The deviation from carrier is about +/-700kHz. The data never...
-
My application has a small device, which draws about a watt, and is powered through a small dynamo, backed by a battery: The dynamo generate...
-
Related question: Ceramic capacitors: how to read 3-digit markings? I have some ceramic capacitors with a 2-digit marking. How to read them?...
-
Looking at all the various schematics of op amps, regulators, etc. I see lots of multicollector or multiemitter BJTs (and why no multibase?)...
-
It is well understood that if you have a device that uses a Lithium-Ion battery, and if the battery starts to bulge, then something is wrong...
-
I'm having an issue with my Silicon Photomultiplier (SiPM) feedback circuit. The output is not behaving as expected. My board schematic ...
No comments:
Post a Comment