I've been searching for a similar circuit and only found latching relays with two momentary switches for on and off. I don't know if this circuit has a specific name or not, and since I am a complete begginer I'm sorry if I missed it somehow. Here's my case.
I have a circuit that runs off a 12V DC power supply with one main switch. I need the circuit to be active when the power supply goes on. Simple enough. What I would need now is a switch that cuts the power to the circuit and keeps it off until the power supply is turned off and on again. So just one switch, no turning the circuit on after it's been pressed.
Answer
This is pretty straightforward. What you need is a single pole, double throw relay with a 12 volt coil and contacts which will handle your load current. Connect it like
simulate this circuit – Schematic created using CircuitLab
When the circuit turns on, there is no power applied to the relay, so it connects the 12V to the load through the NC (normally closed) contact.
When you connect the switch, the relay activates, and the load is disconnected. 12V is applied to the coil, so when the switch is released the relay stays activated, and it will remain so until power is removed.
No comments:
Post a Comment