Is it good practice to parallel relay contacts for increased current capacity?

Say I have a DPDT relay, like T92S7D12-24. The contacts of this relay are rated for 30A, but there are two sets of contacts. Can I parallel the contacts to get an effective 60A relay? Further, could I parallel two (or more) relays and get even more current capacity?

I see two possible problems.

1. Current may not be shared equally between sets of contacts and between relays. One set of contacts could take more than their share of the current and overheat.


2. Switching times may vary between contacts and between relays. When breaking with current through the contacts, the last set of contacts to open may be carrying far more than their recommended current at time of break. This could cause damage.

Are these problems? Are there other problems? If so, can they be quantified and worked around? Or is paralleling contacts and relays always bad design practice?

In my specific application, I'm using these relays as part of precharge for a capacitor bank. They are not expected to switch current. They make once the caps are charged, then hold. They should never open under current flow. Under these specific circumstances, should I still expect problems?

Answer

No you should not do this. Sometimes it is explicitly allowed on the data sheet (but not that I can see on this data sheet), and when it is, in my experience you never get as much as double the capacity.

Paralleling physically separate relays is worse again because they're not physically moving together- expect welded contacts etc. if you tried that.

If you can split the load (for example, instead of a 40A heater use two 20A heaters) then you can get an equivalent functionality.

You could think about ballasting the loads (wasting power to roughly equalize the currents) and fusing each contact separately, but I don't think that's a good idea at all.

Note that using the relay at the maximum rated current will lead to a pretty short life (only 100,000 operations for a resistive load), which might be only weeks or months if it's switching continuously. At 3HP (motor load), the life is only 1,000 operations, so at once per minute it won't last a single day.

Edit: With the added information that you're using the relay to switch effectively at a relatively low DC voltage and you're mostly concerned about carrying current.. I can't say categorically this is really a horrible idea with a single relay, but I think I'd get on the horn to the manufacturer and see if it's possible to get any buy-in. It comes down to variability in contact resistance vs. the resistance of the connections (plus whatever, hopefully balanced, resistance you add externally). When one of the contacts inevitably fails first, I think I would prefer the relay to not emit excessive amounts of smoke or flames). I think you're okay at 40A (with AgCdO contacts) given the UL508 rating, but beyond that is in question.

If you really need such a high carrying current, the Omron G7Z appears to explicitly allow paralleling the 40A contacts without derating, for 160A total capacity, but perhaps not with the blessing of safety agencies.