Saturday, 24 December 2016

power supply - How to drop amperage without losing voltage




Recently, my 3D printer power supply broke. It runs at 9.2A, 24V, and 221W. I then proceeded to hook up a power supply that was much more powerful and runs at 24V, 14A, and 400W.


Using this caused the printer head to print up way hotter and burn through material. Is there any way I could lower the amperage on the power supply without any voltage loss?




-

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...