Answer
Those are phase dots. They refer to the 'start' of the winding based on a predetermined winding direction (CW or CCW). This allows you to tell at a glance what 'polarity' the windings have so you can figure out how the current will flow.
Subscribe to:
Post Comments (Atom)
-
operational amplifier - What is the advantage of the inverting opamp circuit over non-inverting one?Op amp circuits are designed to achieve a specific gain regardless of the differences between individual op amps. One very common circuit ha...
-
Related question: Ceramic capacitors: how to read 3-digit markings? I have some ceramic capacitors with a 2-digit marking. How to read them?...
-
I'm having an issue with my Silicon Photomultiplier (SiPM) feedback circuit. The output is not behaving as expected. My board schematic ...
-
Can you please give me a definition, or at least a more specific context, of the term "point-of-load" converter/regulator? I have ...
-
I have read at numerous places that NAND gate is preferred over NOR gate in industry. The reasons given online say: NAND has lesser delay th...
-
My input is an FM carrier of 80.00MHz. It is FM modulated with 625kbpsec data. The deviation from carrier is about +/-700kHz. The data never...
-
being from a CS background I am a complete noob at this. I'll keep this short. I have a couple of 18650 batteries that i salvaged from a...
No comments:
Post a Comment