microcontroller - STM32 Understanding GPIO Settings

In STM32 Standard Peripheral library, we need to configure the GPIO.

But there are 3 functions which I not sure how to configure them;

• GPIO_InitStructure.GPIO_Speed


• GPIO_InitStructure.GPIO_OType


• GPIO_InitStructure.GPIO_PuPd

In the GPIO_Speed, there are 4 settings to pick from

GPIO_Speed_2MHz  /*!< Low speed */
GPIO_Speed_25MHz /*!< Medium speed */

GPIO_Speed_50MHz /*!< Fast speed */
GPIO_Speed_100MHz

How do I know which speed do I choose from? Is there any advantage or disadvantages using high speed or low speed? (eg: power consumption?)

In the GPIO_OType, there are 2 settings to pick from

GPIO_OType_PP // Push pull
GPIO_OType_OD // Open drain

How to know which to choose from? and what is open drain and push pull?

In the GPIO_PuPd, there are 3 settings to pick from

GPIO_PuPd_NOPULL // No pull
GPIO_PuPd_UP     // Pull up
GPIO_PuPd_DOWN   // Pull down

I think this settings is related to initial setting of push pull.

Answer

• 
  

  GPIO_PuPd (Pull-up / Pull-down)

  
  

  In digital circuits, is is important that signal lines are never allowed to "float". That is, they need to always be in a high state or a low state. When floating, the state is undetermined, and causes a few different types of problems.

  
  
  

  The way to correct this is to add a resistor from the signal line either to Vcc or Gnd. That way, if the line is not being actively driven high or low, the resistor will cause the potential to drift to a known level.

  
  

  The ARM (and other microcontrollers) have built-in circuitry to do this. That way, you don't need to add another part to your circuit. If you choose "GPIO_PuPd_UP", for example, it is equivelent to adding a resistor between the signal line and Vcc.

  
  


• 
  

  GPIO_OType (Output Type):

  
  

  Push-Pull: This is the output type that most people think of as "standard". When the output goes low, it is actively "pulled" to ground. Conversely, when the output is set to high, it is actively "pushed" toward Vcc. Simplified, it looks like this:

  
  

  

  
  

  An Open-Drain output, on the other hand, is only active in one direction. It can pull the pin towards ground, but it cannot drive it high. Imagine the previous image, but without the upper MOSFET. When it is not pulling to ground, the MOSFET is simply non-conductive, which causes the output to float:

  
  

  

  
  

  For this type of output, there needs to be a pull-up resistor added to the circuit, which will cause the line to go high when not driven low. You can do this with an external part, or by setting the GPIO_PuPd value to GPIO_PuPd_UP.

  
  
  

  The name comes from the fact that the MOSFET's drain isn't internally connected to anything. This type of output is also called "open-collector" when using a BJT instead of a MOSFET.

  
  


• 
  

  GPIO_Speed

  
  

  Basically, this controls the slew rate (the rise time and fall time) of the output signal. The faster the slew rate, the more noise is radiated from the circuit. It is good practice to keep the slew rate slow, and only increase it if you have a specific reason.