Sunday, 29 November 2015

Protection of ADC inputs


I am using an ADC MCP3424.


After breaking one of the ADC inputs, I was saw this thread: ADC input protection?



I also read Microchip app note TB3013. Figure 3 in particular:


examples of input pin protection


The ADC's analog inputs need to be clamped at ± 0.3V of the supply rails.


The Vf of a schottky like BAT85 depends on the current flowing through it. So for a Vf < 0.3V, we would need a series resistance of 10k, to keep the current less than 1mA (assuming the Opamp Supply is +15V/-5V). Now the problem is wouldn't the 10k resistance slow down the charging time of the sampling capacitor and reduce my 18-bit accuracy? I am measuring slow moving DC voltages.


Is there any solution for the problem ?



Answer



Putting a 10K resistor on the input will not change things to any great extent. Yes, technically it will slow down charging the sampling cap. It will act as a low pass filter where the cutoff frequency is 1/(2*pi*R*C). That works out to a cutoff frequency of 4.97 MHz. So any frequency above 4.97 MHz will be significantly attenuated.


This ADC has several modes, but the quickest mode it has runs as 240 samples per second. Meaning that it can handle frequencies less than 120 Hz. The RC filter caused by the input cap and the 10K resistor has a frequency response that is still 4 orders of magnitude higher!


In short, that 10k resistor on the input isn't going to do anything negative for you.


No comments:

Post a Comment

arduino - Can I use TI&#39;s cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...