Saturday, 24 January 2015

Parallel MOSFETs to get more current (40A adjustable current source)


In my previous question about an adjustable constant current source, I was advised to use an Op-Amp and a MOSFET to generate a current source that I could adjust with a variable input voltage.


The goal is to test some fuses (normal operating current and time/current to fuse). To do this I would need some 50A (at least).



Here is the original suggested circuit:


current source


(Image source: Learning about Electronics)


The resistor would be replaced by a much lower value (in mOhm to handle to high current). To avoid thermal problems, I'd like to parallel MOSFETs (4 devices). Shall I use one Op-Amp per MOSFET (replicate the whole circuit four times) or shall I use only one Op-Amp?


I think I understand how the single MOSFET circuit works, but I'd need some help to scale it up and avoid me toasting my poor single MOSFET with 40A DC !!


The idea would be to use a car battery as main power source. Vdd around 12V and plenty of amps!




No comments:

Post a Comment

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...