Monday, 27 October 2014

batteries - Does leaving a cell phone on charge all the time weaken the battery, and why?


If I leave my cell phone with the charger plugged in all the time, would this weaken the batter, and why? I've heard that you should only charge the cell phone when you receive a 'battery low' message and leave it off the charger at other times?


The cell phone has got a Li-Ion battery.



Answer




All newer phones use Lithium polymer batteries.


Why is it Partially Charged?


To decrease their aging they are intended to be stored at 40% charge. This means when you receive your phone it should be at 40% charge, otherwise they will have aged your battery for you. (you are probably used to the effects of aging, like a 2 year old phone seeming to have very short battery life). When you get your phone you can use it until it is discharged, but they normally say 'charge it' because people will not notice the partial charge.


Do Not Fully Discharge


You should not fully worry about fully discharging, this is superstition to earlier battery technologies. Fully discharging a lithium battery is one of the best ways to make it fail. below a certain charge they will have their overcharge protection circuitry fail and you cannot charge it at all. I have seen studies that show that this makes up more than 75% of "failed" lithium batteries.


Lithium Battery Aging


Lithium batteries have a set number of charge discharge cycles before they fail. This might be a number like 500 cycles. You actually get more like 1000 cycles if you only discharge to 50% before recharge. Lithiums really do not like a deep discharge, I cannot stress this enough.


If you would like more information about lithium battery technology let me know, I can get you many links, just drop me a comment. I have a few answers on the electronics and robotics stack exchange about it.


Can I leave it plugged in all the time?


Yes, and no. This is very dependent on whom makes your device.

For example, my Lenovo laptop will not apply a charge to the battery unless it is under 97%. When it does charge the battery it charges directly to 100%, then stops until the battery sags below 97%. Many laptops did not do this, on most just applying charge if it is not 100%. This would put the battery through thousands of charge cycles in a week when you are not using the battery. This ages a battery quickly.


If your phone maker took the time and paid the extra cash then your phone will stop charging once it reaches full charge and just power the system from the wall outlet. It is significantly more likely that your phone is charging your battery on a short cycle and aging it thoroughly.


Myths


Some people have some confusion from some of the myths that go about. The primary one is memory. As Battery University will say, this is mostly extinct, and actually applies to nickel-cadmium batteries. As was stated in a comment about crystals Battery university has in reference to nickel-cadmium:



With memory, the crystals grow and conceal the active material from the electrolyte. In advanced stages, the sharp edges of the crystals penetrate the separator, causing high self-discharge or electrical short.



Now, talking about Lithium batteries, which your phone uses, there is even more difference. To quote them battery university directly from their simple guidelines:



Avoid frequent full discharges because this puts additional strain on the battery. Several partial discharges with frequent recharges are better for lithium-ion than one deep one. Recharging a partially charged lithium-ion does not cause harm because there is no memory. (In this respect, lithium-ion differs from nickel-based batteries.) Short battery life in a laptop is mainly cause by heat rather than charge / discharge patterns.




I understand how this may go against what you have been taught, but I am someone who not only has research this but uses lithium batteries in my day to day work as an engineer.


No comments:

Post a Comment

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...