If you have a blackbox that gives you nanovolt signal in the output, how would you collect and process it? Signal to noise ratio is very low. How do you filter the noise? Let's say the frequency range is 0-80Hz in that application. What amplifier would you use? what type of circuit? Thank you
Subscribe to:
Post Comments (Atom)
-
operational amplifier - What is the advantage of the inverting opamp circuit over non-inverting one?Op amp circuits are designed to achieve a specific gain regardless of the differences between individual op amps. One very common circuit ha...
-
Related question: Ceramic capacitors: how to read 3-digit markings? I have some ceramic capacitors with a 2-digit marking. How to read them?...
-
I'm having an issue with my Silicon Photomultiplier (SiPM) feedback circuit. The output is not behaving as expected. My board schematic ...
-
Can you please give me a definition, or at least a more specific context, of the term "point-of-load" converter/regulator? I have ...
-
My input is an FM carrier of 80.00MHz. It is FM modulated with 625kbpsec data. The deviation from carrier is about +/-700kHz. The data never...
-
My application has a small device, which draws about a watt, and is powered through a small dynamo, backed by a battery: The dynamo generate...
-
Looking at all the various schematics of op amps, regulators, etc. I see lots of multicollector or multiemitter BJTs (and why no multibase?)...
No comments:
Post a Comment