When I run this circuit I get the following error:
Unless I set R4 to around 1 Ohm the problem persists. How can I fix this issue?
Subscribe to:
Post Comments (Atom)
-
operational amplifier - What is the advantage of the inverting opamp circuit over non-inverting one?Op amp circuits are designed to achieve a specific gain regardless of the differences between individual op amps. One very common circuit ha...
-
Related question: Ceramic capacitors: how to read 3-digit markings? I have some ceramic capacitors with a 2-digit marking. How to read them?...
-
I'm having an issue with my Silicon Photomultiplier (SiPM) feedback circuit. The output is not behaving as expected. My board schematic ...
-
Can you please give me a definition, or at least a more specific context, of the term "point-of-load" converter/regulator? I have ...
-
My input is an FM carrier of 80.00MHz. It is FM modulated with 625kbpsec data. The deviation from carrier is about +/-700kHz. The data never...
-
My application has a small device, which draws about a watt, and is powered through a small dynamo, backed by a battery: The dynamo generate...
-
Looking at all the various schematics of op amps, regulators, etc. I see lots of multicollector or multiemitter BJTs (and why no multibase?)...
No comments:
Post a Comment