The LM324 quad opamp data here says that it can work in single as well as dual supply mode. However, it has pins for positive supply and another for ground on its sides. The pin for ground can also be used for negative supply as per the datasheet. However, if we shall only connect the +V and -V and no GND, how does the concept of -V arise in the operation of the op-amp?
Subscribe to:
Post Comments (Atom)
-
Can you please give me a definition, or at least a more specific context, of the term "point-of-load" converter/regulator? I have ...
-
My input is an FM carrier of 80.00MHz. It is FM modulated with 625kbpsec data. The deviation from carrier is about +/-700kHz. The data never...
-
My application has a small device, which draws about a watt, and is powered through a small dynamo, backed by a battery: The dynamo generate...
-
Related question: Ceramic capacitors: how to read 3-digit markings? I have some ceramic capacitors with a 2-digit marking. How to read them?...
-
Looking at all the various schematics of op amps, regulators, etc. I see lots of multicollector or multiemitter BJTs (and why no multibase?)...
-
It is well understood that if you have a device that uses a Lithium-Ion battery, and if the battery starts to bulge, then something is wrong...
-
I'm having an issue with my Silicon Photomultiplier (SiPM) feedback circuit. The output is not behaving as expected. My board schematic ...
No comments:
Post a Comment