Wednesday, 7 November 2018

xbee doesn't respond to command sequence


I have two Xbee S6 wifi modules (XB24-WFSIT-001 rev G), DF robot xbee atapter V2 and sparkfun XBee Explorer USB.


I'm able to upload firmware to any of them (version 102D for example) using sparkfun adapter,(not df robot's one), but X-CTU can't set AT parameters after upload. I use this adapter with other xbees and it works fine.


Also it's not possible to enter command mode using +++ sequence, module just ignores it.


I have tried Xbee Factory -Hardware reset without serial communication and it didn't help.




-

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...