Saturday, 25 July 2015

driver - Is it possible to run a stepper motor only with a L293D at reduced current?


I would like to drive my stepper motor (1.4A rated current, 3.5V, 2,5 Ohm coil resistance). I only own some L293D drivers but I think I will burn it if I just wire the motor to the driver without some sort of current limiting.


Obviously I will loose some torque but that's ok for the moment.




-

No comments:

Post a Comment

Subscribe to: Post Comments (Atom)

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...