Monday, 18 November 2019

switch mode power supply - SMPS gives "electric shock"


I built the following circuit, a reference VIPer22A circuit. VIPer22A Reference design


It works fine but I have a little problem. It gives an electric shock on the secondary side. It's not a "line" shock (sticking your fingers into an outlet), but rather, a "tingly" shock if you touch the device while you're grounded.


It's the same thing that happens when you have an PC power supply not connected to mains earth.


The obvious solution would be, of course, to connect the secondary GND to Earth. The problem I have with this is that this is an audio amplifier, so I'd rather leave GND floating.


Is there a way to eliminate this shock? Capacitively connecting GND to EARTH? Or should I just connect my circuit's ground to Earth?





No comments:

Post a Comment

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...