Wednesday 13 August 2014

identification - What is this connector called?



I need to repair some kit that uses several connectors like the one pictured below. The existing connections have become brittle and are breaking off.


The wires appear to be crimped into the connector somehow. Is there a special tool I need to re-attach them?


connector connector other side



Answer



Update:


As Passerby notes in a comment, the connector in your picture appears to be keyed. In which case it is not a generic 0.1" header connector. It may or may not have differing latching arrangements.


Original Answer:



What is the connector called




They are called header connectors, designed for (usually) 0.1 inch pitch connectors. They mate with header pins.


The housings come as singles or as strips of several combined, you can make up cables from parts or buy pre-assembled sets like these:



The last two items are useful in that you can tear off a group of as many connectors as needed for a specific application. You can cut the cable in half to make a lead that can be soldered at one end.



The wires appear to be crimped into the connector somehow.



Usually the wire is crimped to a metal recaptacle and the assembly then is pushed into a housing that has a plastic latch to hold the assembly in place:


enter image description here one side has a latching tang
enter image description here use a knife to lift the retaining tang

enter image description here like so
enter image description here then the wire slides out of the housing



Is there a special tool I need to re-attach them?



No, just push them back together, so long as the plastic tang is pushed into it's original position, it will lock the metal receptacle in place.


No comments:

Post a Comment

arduino - Can I use TI's cc2541 BLE as micro controller to perform operations/ processing instead of ATmega328P AU to save cost?

I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...