I plan to connect balanced TRS output with unbalanced TS input and I wonder if instead of cutting the cable and leaving ring floating I could just cover the male jack itself (the ring part that goes to the unbalanced input) with insulation tape. My guess is it should prevent the signal from the ring connect with the sleeve of the unbalanced, TS input.
Subscribe to:
Post Comments (Atom)
-
I'm having an issue with my Silicon Photomultiplier (SiPM) feedback circuit. The output is not behaving as expected. My board schematic ...
-
In all the texts I encountered so far, I find the following pole-zero diagram example for an RLC series circuit: The transfer function for t...
-
I am using arduino pro mini (which contains Atmega328p AU ) along with cc2541(HM-10) to process and transfer data over BLE to smartphone. I...
-
being from a CS background I am a complete noob at this. I'll keep this short. I have a couple of 18650 batteries that i salvaged from a...
-
As asynchronous serial communication is widely spread among electronic devices even nowadays, I believe many of us have encountered such a q...
-
I have a transformer based AC fan controller (rated for 230V input) with five output steps ( 230V(5) - 200V(4) - 160V(3) - 140V(2) - 125V(1)...
-
I have a project which uses a TI step down converter ( LMZ14201 ) to buck an input voltage (up to 41V) down to a regulated 5V. Until now, I ...
No comments:
Post a Comment