My solid state relay seems to be dropping the potential by 35 volts. I read about 80 volts from one end of a modified plug and the other end is plugged into a 120 volt wall socket. I have the hot wire cut and the ends connected to the leads of the relay. The neutral wire is not cut anywhere. I knew there would be a small internal resistance but not by this much. Is there something I am missing? I would simply like to control a 120 volt lamp with my arduino.
Subscribe to:
Post Comments (Atom)
-
In all the texts I encountered so far, I find the following pole-zero diagram example for an RLC series circuit: The transfer function for t...
-
As asynchronous serial communication is widely spread among electronic devices even nowadays, I believe many of us have encountered such a q...
-
Translation: Find the supplied power from the 4V Source using meshes method I proposed five equations related with the circuit but I only fi...
-
Here's what I have so far but I'm stuck with what to do for the f values for the last two and whether the if statement syntax is cor...
-
I am currently working on a simple circuit involving logic gates in Proteus ISIS from Labcenter. By default, the power pins are hidden. You ...
-
I am building a battery-powered uC circuit with an RGB LED. The LED is common cathode, so the circuit for switching the LED elements has to ...
-
I am designing and building circuits which use 100Mb/s on a Low Voltage Differential Signaling (LVDS) bus. Some of these signals need to tra...
No comments:
Post a Comment