I mainly use this high-side switch design for 5V and with low current loads (under 100mA).
Based on the VDSS (-50V), I thought I could energize this design with 24V as well. Apparently, I am making a mistake by interpreting the VDSS. Even there is no load attached (Drain is only connected to voltmeter), when I connect to 24V source, Mosfet doesn't response to I/O input change (High or Low) anymore and always stays ON. Even I connect to a 5V source again, it still stays ON, another saying I believe the mosfet is gone.
Would you please tell me what is wrong here?
No comments:
Post a Comment